P1713-RESTRICTED MANUAL VALVE IN T2 RANGE
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Ignition on, engine running with the gear shift selector in a valid forward gear.
- Set Condition:
This DTC sets whenever Transmission control system detects the manual valve is in the T2 range when it should be in OD. This is mainly an informational DTC.
| Possible Causes |
| RELATED TRANSMISSION DTCS PRESENT |
| CUSTOMER DRIVING HABITS |
| MIS-ADJUSTED SHIFTER CABLE |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)
Diagnostic Test
1.DETERMINING IF RELATED DTCS ARE PRESENTAre there any speed sensor or gear ratio DTCs present?
Yes
- Refer to the Transmission category and perform the appropriate symptom.
No
- Go To2
2.CHECK THE GEAR SHIFT CABLE FOR PROPER ADJUSTMENT
Is the Gear shift cable properly adjusted and not binding or improperly routed?
Yes
- Go To3
No
- Adjust the Shifter Assembly per the Service Information.
- Perform 42RLE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)
3.CHECK CUSTOMER DRIVING HABIT
If there are no possible causes remaining, view repair.
Repair
- This DTC can be set by the shift lever in the wrong position or not completely in the OD position. Make sure the customer is properly informed.
- Perform 42RLE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)