U0429-IMPLAUSIBLE DATA RECEIVED FROM SCM
For a complete wiring diagram Refer to Section 8W
- When Monitored:
Continuously while the system is active.
- Set Condition:
An error message has been received over the bus from the Steering Control Module (SCM).
| Possible Causes |
| INTERMITTENT DTC |
| CAN BUS OPEN OR SHORTED CONDITION |
| STEERING CONTROL MODULE (SCM) |
| ENGINE CONTROL MODULE (ECM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)
Diagnostic Test
1.ACTIVE DTCNOTE: Diagnose all CAN B and C communication DTCs before continuing.
Is the status Active for this DTC?
Yes
- Go To 2
No
- Refer to the INTERMITTENT CONDITION Diagnostic Procedure. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)
2.SCM COMMUNICATION RELATED DTC'S IN OTHER MODULES
Are there any SCM communication related DTCs in other modules on the CAN Bus at this time?
Yes
- Replace and program the Steering Control Module (SCM) in accordance with the Service Information.
- Perform the ECM Verification Test Ver. 1. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)
No
- Replace and program the Engine Control Module (ECM) in accordance with the Service Information.
- Perform the ECM Verification Test Ver. 1. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)