U0415-IMPLAUSIBLE DATA RECEIVED FROM ABS

For a complete wiring diagram Refer to Section 8W

When Monitored:
Continuously while the system is active.
Set Condition:
An error message has been received over the bus from the Anti-lock Brake Module.

Possible Causes

INTERMITTENT DTC

CAN BUS OPEN OR SHORTED CONDITION

ANTI-LOCK BRAKE MODULE

ENGINE CONTROL MODULE (ECM)

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)

1.ACTIVE DTC

NOTE: Diagnose all CAN B and C communication DTCs before continuing.

Is the status Active for this DTC?

Yes

Refer to the INTERMITTENT CONDITION Diagnostic Procedure. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)
Perform the ECM Verification Test Ver. 1.

2.ABS COMMUNICATION RELATED DTC'S IN OTHER MODULES

Are there any ABS communication related DTCs in other modules on the CAN Bus at this time?

Yes

Replace and program the Anti-Lock Brake Control Module (ABS) in accordance with the Service Information.
Perform the ECM Verification Test Ver. 1. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)

Replace and program the Engine Control Module (ECM) in accordance with the Service Information.
Perform the ECM Verification Test Ver. 1. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)