C121D–BRAKE PRESSURE SENSOR CIRCUIT

For a complete wiring diagram Refer to Section 8W.

• When Monitored:

  With the ignition on.

• Set Condition:

  When the Anti-Lock Brake Module indicates that the Brake Pressure Sensor Signal is out of range.

Diagnostic Test

NOTE: This DTC must be active for the results of this test to be valid.

• Go To 2

• Refer to the INTERMITTENT CONDITION diagnostic procedure.
• Refer to the ABS-INTERMITTENT CONDITION TEST. (Refer to 5 - BRAKES - DIAGNOSIS AND TESTING)

• Replace the ICU in accordance with the Service Information.
• Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE).

• Test complete