ITM–EEPROM FAILURE (EXPORT ONLY)

For a complete wiring diagram Refer to Section 8W

When Monitored:
Continuously while the VTSS is armed and during change of the VTSS state.
Set Condition:
If the EEPROM erase/write does not correctly complete the operation.

Possible Causes

INTRUSION TRANSCEIVER MODULE (ITM)

1.VERIFY THAT THE DTC IS ACTIVE

Did this DTC reset?

Yes

Replace the ITM in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).

The condition that caused this symptom is currently not present. Test complete.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).