PASSENGER PRESSURE SENSOR OPEN

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition on.

  • Set Condition:

    If the Occupant Classification Module (OCM) detects voltage above the high threshold on the Passenger Bladder Pressure Sensor Signal circuit.



Diagnostic Test

1.DETERMINE ACTIVE OR STORED DTC

NOTE: Ensure that the battery is fully charged.




SELECT ACTIVE or STORED DTC:

ACTIVE DTC
  • Refer to *Belt Tension Sensor / Pressure Sensor Faults for the diagnostic procedure.


STORED DTC
  • Go To 2

2.INSPECT THE OCCUPANT CLASSIFICATION SYSTEM (OCS) WIRING AND CONNECTORS FOR CONDITIONS THAT CAUSED THE DTC(s) TO SET

NOTE: Diagnose and repair all active codes before diagnosing stored codes. Refer to the Table of Contents in this Section for a complete list of airbag system diagnostic procedures.



WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.




Are any of these conditions present?

Yes

  • WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and personal injury or death.

    NOTE: The Occupant Classification Module (OCM) and the Passenger Seat Bladder and Cushion Kit are the only serviceable OCS components.

  • Replace the OCS Bladder and Cushion Kit in accordance with the Service information.
  • Perform System Verification Required test.
  • Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.


No
  • Go To 3

3.TEST FOR AN INTERMITTENT CONDITION


WARNING: To avoid personal injury or death, turn the ignition on, then reconnect the battery.


  • Wiggle the wiring harness and connectors of the related circuit.
  • Continue the test until either a code becomes active or the problem area is isolated.



Are any ACTIVE DTCs present?

Yes
  • Select the appropriate diagnostic procedure from the Table of Contents in this section.


No
  • No problem found at this time. Erase all codes before returning the vehicle to the customer.