OCM CONFIGURATION MISMATCH





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    At ignition on.

  • Set Condition:

    The Occupant Restraint Controller (ORC) monitors the Bus for the Occupant Classification Module (OCM) messages and then compares the messages to the known configuration. The ORC will set this DTC if it is not configured for Passenger Only OCM and OCM messages are broadcast on the Bus.


Possible Causes
 
PCM
 
ORC
 




Diagnostic Test

1.DETERMINE ACTIVE OR STORED DTC

NOTE: Ensure that the battery is fully charged.



Select ACTIVE or STORED DTC:

ACTIVE DTC
  • Go To 2


STORED DTC
  • Go To 3

2.VERIFY THAT THE PCM IS PROGRAMMED WITH THE CORRECT VIN




Does the current VIN match the VIN on the vehicle VIN plate?

Yes
  • WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and personal injury or death.

    WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

  • Replace the ORC in accordance with the Service Information.
  • Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.


No

3.CHECKING STORED OR INTERMITTENT CODES

NOTE: Diagnose and repair all active codes before diagnosing stored codes. Refer to the Table of Contents in this Section for a complete list of airbag system diagnostic procedures.






Does the scan tool display any DTCs?

Yes
  • Select the appropriate diagnostic procedure from the Table of Contents in this section.


No
  • No problem found at this time. Erase all codes before returning vehicle to customer.