CLUSTER MESSAGE MISMATCH

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition on following the instrument cluster (MIC) bulb check.

  • Set Condition:

    The Occupant Restraint Controller (ORC) broadcasts the Airbag Lamp On/Off request message on the Bus one time each second. In turn, the MIC broadcasts the Airbag Lamp On/Off status message on the Bus one time each second. The ORC compares the request message and the status message and will set this DTC if they do not match.


Possible Causes
 
INSTRUMENT CLUSTER (IC)
 
OCCUPANT RESTRAINT CONTROLLER (ORC)
 




Diagnostic Test

1.DETERMINE ACTIVE OR STORED DTC

NOTE: Ensure that the battery is fully charged.

NOTE: When disconnecting or connecting airbag system components, the ignition must be turned off and the battery must be disconnected.




Select ACTIVE or STORED DTC:

ACTIVE DTC
  • Go To 2


STORED DTC
  • Go To 4

2.CHECK FOR ACTIVE MIC DTCs



Does the scan tool display any DTCs?

Yes


No
  • Go To 3

3.VERIFY THAT THE AIRBAG LAMP REQUEST AND STATUS MESSAGE MATCH





Does the ABAG IND REQ BY ACM status match the ABAG IND ON BY MIC status?

Yes
  • WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

    WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and personal injury or death.

  • Replace the ORC in accordance with the Service Information.
  • Perform the *AIRBAG SYSTEM VERIFICATION TEST - VER 1.


No

4.CHECKING STORED OR INTERMITTENT CODES

NOTE: Diagnose and repair all active codes before diagnosing stored codes. Refer to the Table of Contents in this Section for a complete list of airbag system diagnostic procedures.






Does the scan tool display any active DTCs?

Yes
  • Select the appropriate diagnostic procedure from the Table of Contents in the applicable section.


No
  • No problem found at this time. Erase all codes before returning vehicle to customer.