OIL PRESSURE SENSOR FAULTED LOW (BCM)





For a complete wiring diagram Refer to Section 8W.

Diagnostic Test


  • When Monitored:

    With the ignition on.

  • Set Condition:

    Oil Pressure Sensor voltage low.


Possible Causes
 
(K301) 5-VOLT SUPPLY CIRCUIT
 
(K302) OIL PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO GROUND
 
(K302) OIL PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO THE (K300) SENSOR GROUND CIRCUIT
 
(K301) 5-VOLT SUPPLY CIRCUIT OPEN
 
(K301) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
 
OIL PRESSURE SENSOR
 
BCM
 




Diagnostic Test

1.OIL SENSOR VOLTAGE BELOW 0.08 OF A VOLT




Is the voltage below 0.08 of a volt?

Yes
  • Go To 2


No

2.(K301) 5-VOLT SUPPLY CIRCUIT








Is the voltage between 4.5 to 5.2 volts?

Yes
  • Go To 3


No
  • Go To 6

3.OIL PRESSURE SENSOR



Is the voltage above 4.5 volts?

Yes


No
  • Go To 4

4.(K302) OIL PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO GROUND







Is the resistance below 100 ohms?

Yes


No
  • Go To 5

5.(K302) OIL PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO THE (K300) SENSOR GROUND CIRCUIT





Is the resistance below 100 ohms?

Yes


No
  • Go To 6

6.(K301) 5-VOLT SUPPLY CIRCUIT OPEN







Is the resistance below 5.0 ohms?

Yes
  • Go To 7


No

7.(K301) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND





Is the resistance below 100 ohms?

Yes


No
  • Go To 8

8.BCM

NOTE: Before continuing, check the BCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.




Were there any problems found?

Yes


No