DIAGNOSIS AND TESTING - ENGINE DIAGNOSIS - MECHANICAL


CONDITION
 
POSSIBLE CAUSES
 
CORRECTIONS
 
NOISY VALVES
 
1. High or low oil level in crankcase.
 
1. (Refer to LUBRICATION & MAINTENANCE/FLUID TYPES - SPECIFICATIONS).
 
2. Thin or diluted oil.
 
2. Change oil and filter.
 
 
3. Low oil pressure.
 
3. Check oil pump, if Ok, check rod and main bearings for excessive wear.
 
 
4. Dirt in lash adjusters.
 
4. Clean or replace as necessary.
 
 
5. Worn rocker arms.
 
5. Replace as necessary.
 
 
6. Worn valve guides.
 
6. (Refer to 9 - ENGINE/CYLINDER HEAD/INTAKE/EXHAUST VALVES & SEATS - STANDARD PROCEDURE).
 
 
7. Excessive runout of valve seats.
 
7. Service valves and valve seats (Refer to 9 - ENGINE/CYLINDER HEAD/INTAKE/EXHAUST VALVES & SEATS - STANDARD PROCEDURE)
 
 
ENGINE VIBRATION
 
1. Counter Balance Shaft not timed properly
 
1. Refer to Engine Timing in this section
 
CONNECTING ROD NOISE
 
1. Insufficient oil supply.
 
1. (Refer to LUBRICATION & MAINTENANCE/FLUID TYPES - SPECIFICATIONS).
 
2. Low oil pressure.
 
2. Check oil pump, if Ok, check rod and main bearings for excessive wear.
 
 
3. Thin or diluted oil.
 
3. Change oil and filter.
 
 
4. Excessive bearing clearance.
 
4. Replace as necessary.
 
 
5. Connecting rod journal out-of-round.
 
5. Service or replace crankshaft.
 
 
6. Misaligned connecting rods.
 
6. Replace bent connecting rods.
 
 
MAIN BEARING NOISE
 
1. Insufficient oil supply.
 
1. (Refer to LUBRICATION & MAINTENANCE/FLUID TYPES - SPECIFICATIONS).
 
2. Low oil pressure.
 
2. Check oil pump, if Ok, check rod and main bearings for excessive wear.
 
 
3. Thin or diluted oil.
 
3. Change oil and filter.
 
 
4. Excessive bearing clearance.
 
4. Replace as necessary.
 
 
5. Excessive end play.
 
5. Check thrust washers for wear.
 
 
6. Crankshaft journal out-of round.
 
6. Service or replace crankshaft.
 
 
7. Loose flywheel or torque converter.
 
7. Tighten to correct torque