P0610-MANUAL TRANSMISSION CODED AS AUTOMATIC TRANSMISSION

For a complete wiring diagram Refer to Section 8W

When Monitored:
With the ignition on.
Set Condition:
The ECM detects an automatic transmission when it has been programmed for a manual transmission.

Possible Causes

ENGINE CONTROL MODULE

VERIFY ECM PROGRAMMING

1.VERIFY ECM PROGRAMMING

NOTE: Reprogram the ECM with correct information if necessary.

Did this DTC set again?

Yes

Replace and program the Engine Control Module in accordance with the Service Information.
Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).

Test complete.
Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).