B2206-CURRENT VIN MISSING/MISMATCH





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    During power-up, the Occupant Restraint Controller (ORC) and Occupant Classification Module (OCM) monitors the CAN bus for the VIN message.

  • Set Condition:

    This DTC will set if the VIN information received from the Powertrain Control Module (PCM) is different from the stored VIN.


Possible Causes
  
INCORRECT VIN PROGRAMMED INTO THE PCM
  
OCCUPANT CLASSIFICATION MODULE (OCM)
  



Diagnostic Test

1.CHECK FOR ACTIVE DTC

NOTE: Troubleshoot any Ignition, Battery, Seat Weight Sensor, or OCM Internal DTCs BEFORE proceeding

NOTE: Ensure that the battery is fully charged.

NOTE: This DTC cannot be cleared until the *OCM SYSTEM VERIFICATION TEST has been completed successfully.




Select the module and DTC type.

OCM-Active
  • Go To 2


OCM-Stored
  • Erase code with scan tool, test complete.

2.CHECK THE VIN STORED IN THE PCM



Does the VIN stored in the PCM match the vehicle's VIN?

Yes
  • Go To 3


No


Diagnostic Test

3.PERFORM THE OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST

NOTE: Ensure that the battery is fully charged.

NOTE: The Occupant Classification Seat Weights 9077 are required to perform this test.




WARNING: To avoid personal injury or death, turn the ignition on, then reconnect the battery.


NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: verify that all tests steps that led you here were performed as directed; verify that the ignition is in run; Wait 30 seconds after changing the seat weight before proceeding to allow the system to stabilize; only press scan tool buttons when directed to do so; and perform the Occupant Classification Module System Verification Test to completion.





Does the scan tool display any active: B2206-CURRENT VIN MISSING/MISMATCH DTCs?

Yes
  • Go To 4


No
  • Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.

4.PERFORM OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST

WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.




NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: verify that all tests steps that led you here were performed as directed; verify that the ignition is in run; Wait 30 seconds after changing the seat weight before proceeding to allow the system to stabilize; only press scan tool buttons when directed to do so; and perform the Occupant Classification Module System Verification Test to completion.





Does the scan tool display active: B2206-CURRENT VIN MISSING/MISMATCH?

Yes
  • Replace the OCM in accordance with the Service Information.
  • replace the Service Kit if a seat from another vehicle was installed.
  • Perform *OCM SYSTEM VERIFICATION TEST.


No - But Other DTCs Present
  • Diagnose and repair the other DTCs. Refer to the Table of Contents in this Section for a complete list of symptoms.


No - No Active DTCs Present
  • Erase all codes before returning vehicle to customer.