*DRIVER DOOR LOCK INOPERATIVE





For a complete wiring diagram Refer to Section 8W.



Possible Causes
 
(P930) DRIVER DOOR LOCK DRIVER CIRCUIT OPEN
 
(P930) DRIVER DOOR LOCK DRIVER CIRCUIT SHORT TO GROUND
 
(P910) DRIVER DOOR UNLOCK DRIVER CIRCUIT OPEN
 
(P910) DRIVER DOOR UNLOCK DRIVER CIRCUIT SHORT TO GROUND
 
DRIVER DOOR LATCH
 
TOTALLY INTEGRATED POWER MODULE (TIPM)
 




Diagnostic Test

1.DRIVER DOOR LATCH INOPERATIVE








Does the test light illuminate brightly for approximately 300 ms. when the door locks are actuated?

Yes


No
  • Go To 2

2.CHECK (P910) DRIVER DOOR UNLOCK DRIVER CIRCUIT OPEN







Is the resistance below 2.0 ohms?

No
  • Using the wiring diagram/schematic as a guide, measure the circuit from the in-line door harness connector to the latch connector to determine if the wire is open in the door harness or the instrument panel harness. Repair the (P910) Driver Door Unlock Driver circuit for an open.
  • Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)


Yes
  • Go To 3

3.CHECK (P910) DRIVER DOOR UNLOCK DRIVER CIRCUIT SHORT TO GROUND





Is the resistance below 1000.0 ohms?

Yes
  • Using the wiring diagram/schematic as a guide, measure the circuit from the in-line door harness connector to ground to determine if the wire is shorted in the door harness or the instrument panel harness. Repair the (P910) Driver Door Unlock Driver circuit for a short to ground.
  • Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)


No
  • Go To 4

4.CHECK (P930) DRIVER DOOR LOCK DRIVER CIRCUIT OPEN





Is the resistance below 2.0 ohms?

Yes
  • Go To 5


No
  • Using the wiring diagram/schematic as a guide, measure the circuit from the in-line door harness connector to the latch connector to determine if the wire is open in the door harness or the instrument panel harness. Repair the (P930) Driver Door Lock Driver circuit for an open.
  • Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

5.CHECK (P930) DRIVER DOOR LOCK DRIVER CIRCUIT SHORT TO GROUND





Is the resistance below 1000.0 ohms?

Yes
  • Using the wiring diagram/schematic as a guide, measure the circuit from the in-line door harness connector to ground to determine if the wire is shorted in the door harness or the instrument panel harness. Repair the (P930) Driver Door Lock Driver circuit for a short to ground.
  • Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)


No