B1664-REAR FOG LAMP CONTROL CIRCUIT HIGH

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    Continuously.

  • Set Condition:

    The Totally Integrated Power Module (TIPM) Detects a HIGH condition.


Possible Causes
 
(L239) REAR FOG LAMP CONTROL CIRCUIT OPEN
 
(L239) REAR FOG LAMP CONTROL CIRCUIT SHORTED TO VOLTAGE
 
LEFT AND/OR RIGHT REAR FOG LAMP BULBS
 
TOTALLY INTEGRATED POWER MODULE
 




Diagnostic Test

1.INTERMITTENT CONDITION






Does the scan tool display active: B1664-REAR FOG LAMP CONTROL CIRCUIT HIGH?

Yes
  • Go To 2


No
  • The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
  • Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

2.LEFT AND RIGHT REAR FOG LAMP BULBS





Are the inoperative bulbs OK?

Yes
  • Go To 3


No

3.(L239) REAR FOG LAMP CONTROL CIRCUIT OPEN





Is the resistance below 10.0 ohms?

Yes
  • Go To 4


No

4.(L239) REAR FOG LAMP CONTROL CIRCUIT SHORTED TO VOLTAGE




Is there any voltage present?

Yes


No