B2142 IGNITION OFF DRAW (IOD) FUSE NOT PRESENT
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the Ignition on.
- Set Condition:
IOD Fuse not installed in the TIPM.
| Possible Causes |
| IOD FUSE |
Diagnostic Test
1.CHECK FOR ACTIVE DTCDoes the scan tool display this DTC as active?
Yes
- Go To 2
No
- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
2.IOD FUSE INSTALLED
Is IOD Fuse present?
Yes
- Go To 3
No
- Install the IOD Fuse.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
3.IOD FUSE BLOWN CHECK
Is IOD Fuse blown?
Yes
- Replace the IOD Fuse.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Test complete.