B10C1–A/C SELECT SWITCH STUCK (CCN)

For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition on.

  • Set Condition:

    If the Instrument Cluster (CCN) detects that the A/C mode switch stays in a pushed position for more than 5 seconds.


Possible Causes
 
DTC B1001 OR B1002 ACTIVE IN THE CCN
 
OBJECT HOLDING A/C MODE SWITCH IN A PUSHED POSITION
 
SUBSTANCE CAUSING A/C MODE SWITCH TO GET STUCK IN A PUSHED POSITION
 
A/C HEATER CONTROL
 




Diagnostic Test

1.CHECK FOR ACTIVE DTC B1001 OR B1002 IN THE CCN




Does the scan tool display active: B1001 or B1002?

Yes
  • Diagnose and repair the DTC. Refer to the Table of Contents in this Section.


No
  • Go To 2

2.INSPECT THE A/C HEATER CONTROL FOR DAMAGE




Is the A/C Heater Control damaged?

Yes


No
  • Go To 3

3.INSPECT FOR OBJECT OR SUBSTANCE CAUSING THE A/C MODE SWITCH TO STAY OR STICK IN A PUSHED POSITION



Is anything present that would cause the A/C mode switch to stay or stick in a pushed position?

Yes


No
  • Go To 4

4.CHECK THE A/C MODE SWITCH & STATUS INDICATOR FUNCTION





Does the A/C status indicator turn on and off?

Yes
  • Go To 5


No

5.VERIFY THAT DTC B10C1–A/C SELECT SWITCH STUCK IS STILL ACTIVE






Does the scan tool display active: B10C1–A/C SELECT SWITCH STUCK?

Yes


No
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)