C0077- LOW TIRE PRESSURE

For a complete wiring diagram Refer to Section 8W.

Theory of Operation


  • When Monitored:

    Continuously.

  • Set Condition:

    A low pressure condition will exist when the tire pressure falls below or is equal to the low pressure threshold value as specified for the vehicle.


Possible Causes
 
INTERMITTENT PERFORMANCE DTC
 
INCORRECT PLACARD VALUES
 
INCORRECT TIRE PRESSURE
 
TIRE PRESSURE SENSOR
 
WCM (SKREEM)
 




Diagnostic Test

1.

NOTE: If the incorrect Placard Values were programmed into the WCM/SKREEM, a DTC could be set. Before continuing with any TPM diagnostic test, using the scan tool, check that the correct Placard Values have been programmed in to the module.

NOTE:

If the following conditions are present:

– Low Tire Pressure DTC (C0077) (Active)

– Spare Tire is not equipped with a Tire Pressure Sensor

– Spare Tire is currently on the vehicle

Repair the tire and place it back on the vehicle.

Test drive the vehicle.

If the DTC(s) reset continue with the diagnostic procedure.





Is the DTC status Active at this time?

Yes
  • Go to 2


No
  • Go to 5

2.INCORRECT PLACARD VALUES



Does the programed placard values equal the placard value on the vehicle?

Yes
  • Go to 3


No

3.LOW TIRE PRESSURE




Are all tire pressure values at or exceed placard values?

Yes
  • Go to 4


No

4.TIRE PRESSURE SENSOR

NOTE: Before continuing, ensure the tire is free from any leaks or damage that would cause a low tire pressure condition. If a problem is found, repair as necessary and retest.








Does the DTC reset or is the status Active for this DTC?

Yes


No

5.INTERMITTENT TIRE PRESSURE SENSOR DTC







Does the DTC reset or is the status Active for this DTC?

Yes


No