P0562-BATTERY VOLTAGE LOW





For a complete wiring diagram Refer to Section 8W.

Theory of Operation


Transmission damage may occur if there is insufficient supply voltage to properly control the solenoids. To prevent this possibility, the battery voltage is monitored and the system is placed in logical limp-in if the battery voltage drops below the limit.


  • When Monitored:

    With the engine running and the PCM has closed the Transmission Control Relay.

  • Set Condition:

    If the battery voltage of the Transmission Control Relay Output Sense circuit(s) to the PCM is less than 10.0 volts for the period of 15 seconds. Note: P0562 generally indicates a gradually falling battery voltage or a resistive connection(s) to the PCM. The DTC will also set if the battery voltage sensed at the PCM is less than 6.5 volts for 200ms or when Transmission Control Relay Output circuits are less than 7.2 volts for 200ms.


Possible Causes
 
RELATED CHARGING SYSTEM DTC'S
 
TRANSMISSION CONTROL RELAY
 
(Z903) GROUND CIRCUIT OPEN OR HIGH RESISTANCE
 
(T16) TRANSMISSION CONTROL OUTPUT TO TCM OPEN OR HIGH RESISTANCE
 
TOTALLY INTEGRATED POWER MODULE (TIPM)
 
POWERTRAIN CONTROL MODULE
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)

Theory of Operation


Transmission damage may occur if there is insufficient supply voltage to properly control the solenoids. To prevent this possibility, the battery voltage is monitored and the system is placed in logical limp-in if the battery voltage drops below the limit.



Diagnostic Test

1.CHECK FOR RELATED CHARGING SYSTEM DTC'S



Are there any Charging System related DTCs present?

Yes


No
  • Go To 2

2.CHECK FOR TIPM DTCS

NOTE: Generator, battery, and charging system must be fully functional before performing this test.




Are there any TIPM TCM Power Control Circuit DTCs present also?

Yes
  • Refer to the Transmission category and perform the appropriate symptom.


No
  • Go To 3

3.CONDITION P0562 PRESENT



NOTE: This counter only applies to the last DTC set.



Is the STARTS SINCE SET counter set at 0?

Yes
  • Go To 4


No
  • Go To 6

4.CHECK THE (Z903) GROUND CIRCUITS FOR AN OPEN





NOTE: Check connectors - Clean/repair as necessary.


CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller tool #8815 to perform diagnosis.



NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.



Does the test light illuminate brightly for all the Ground circuits?

Yes
  • Go To 5


No

5.CHECK THE (T16) TRANSMISSION CONTROL OUTPUT CIRCUIT FOR AN OPEN









NOTE: The (T16) Transmission Control Output circuit branches off to both Transmission Solenoid/Pressure Switch Assembly, PCM and (if equipped) the Line Pressure Sensor/Variable Force Solenoid Assembly.



Does the test light illuminate brightly while cycling on and off on all (T16) Transmission Control Output circuits?

Yes
  • Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the PCM per the Service Information. With the scan tool, perform QUICK LEARN.
  • Perform 42RLE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)


No

6.INTERMITTENT WIRING AND CONNECTORS






Were there any problems found?

Yes


No
  • Test Complete.