P0688-AUTO SHUTDOWN SENSE CIRCUIT LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With ignition key on. Battery voltage greater than 10 volts.

  • Set Condition:

    No voltage sensed at the PCM when the ASD is energized or voltage is sensed when the ASD is not energized. One Trip Fault. Three good trips to turn off the MIL.


Possible Causes
 
(F342) ASD CONTROL OUTPUT CIRCUIT SHORTED TO VOLTAGE
 
(F342) ASD CONTROL OUTPUT CIRCUIT OPEN
 
(F342) ASD CONTROL OUTPUT CIRCUIT SHORTED TO GROUND
 
TIPM
 
PCM
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).



Diagnostic Test

1.VERIFY ASD DTC

NOTE: Diagnose P0685 - Auto Shutdown Control Circuit first if it set along with this DTC.





Is the DTC currently Active?

Yes
  • Go To 2


No

2.EXCESSIVE RESISTANCE IN THE (F342) ASD CONTROL OUTPUT CIRCUIT






CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool #8815 to perform diagnosis.




Is the resistance below 5.0 ohms?

Yes
  • Go To 3


No

3.EXCESSIVE RESISTANCE IN THE (F342) ASD CONTROL OUTPUT CIRCUIT






Is the resistance below 5.0 ohms at each terminal?

Yes
  • Go To 6


No

4.(F342) ASD CONTROL OUTPUT CIRCUIT SHORTED TO GROUND





Is the resistance below 100 ohms?

Yes


No
  • Go To 5

5.(F342) ASD CONTROL OUTPUT CIRCUIT SHORTED TO VOLTAGE






Is the voltage above 0 volts?

Yes


No
  • Go To 6

6.TIPM







Does the test light illuminate brightly and flash on an off during the actuation?

Yes
  • NOTE: Before continuing, check the TIPM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.

    If OK, replace the TIPM in accordance with the Service Information.


No
  • Go To 7

7.PCM

NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.




Were there any problems found?

Yes


No