P0580-SPEED CONTROL SWITCH 1 CIRCUIT LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    With the ignition key on.

  • Set Condition:

    Speed control switch input No.1 is below the minimum acceptable voltage at the PCM. One trip fault.


Possible Causes
 
(V71) S/C SIGNAL 1 CIRCUIT SHORTED TO THE (V937) S/C RETURN
 
(V71) S/C SIGNAL 1 CIRCUIT SHORTED TO GROUND
 
SPEED CONTROL SWITCH
 
PCM
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).



Diagnostic Test

1.SPEED CONTROL SWITCH VOLTAGE LOW

NOTE: Do not press the Speed Control Switch button.





Is the Speed Control voltage below 1.0 volt?

Yes
  • Go To 2


No

2.SPEED CONTROL SWITCH













Does the function on the Speed Control Switch have the correct resistance value?

Yes
  • Go To 3


No

3.SPEED CONTROL SWITCH




Did the voltage change to above 4.8 volts?

Yes


No
  • Go To 4

4.(V71) S/C SIGNAL 1 CIRCUIT SHORTED TO THE (V937) S/C RETURN CIRCUIT







Is the resistance below 5.0 ohms?

Yes


No
  • Go To 5

5.(V71) S/C SIGNAL 1 CIRCUIT SHORTED TO GROUND






Is the resistance below 100 ohms?

Yes


No
  • Go To 6

6.SPEED CONTROL SWITCH VOLTAGE VALUES




SWITCH POSITION
 
SWITCH No.1 VOLTAGE VALUE
 
SWITCH No.2 VOLTAGE VALUE
 
NO SWITCHES PRESSED
 
4.31 to 4.78 volts
 
4.31 to 4.78 volts
 
ON/OFF PRESSED
 
0.59 to 1.13 volts
 
3.53 to 3.92 volts
 
RES/ACCEL PRESSED
 
3.88 to 4.17 volts
 
2.04 to 2.47 volts
 
SET PRESSED
 
3.16 to 3.56 volts
 
1.17 to 1.56 volts
 
COAST PRESSED
 
2.57 to 2.94 volts
 
0.77 to 1.09 volts
 
CANCEL PRESSED
 
1.59 to 1.99 volts
 
2.84 to 3.25 volts
 





Are the voltage readings out of the listed specification and is there less than a 0.2 of a volt difference between the voltmeter switch values and the scan tool switch value?

Yes


No
  • Go To 7

7.PCM

NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.




Were there any problems found?

Yes


No