P0462-FUEL LEVEL SENSOR 1 CIRCUIT LOW





For a complete wiring diagram Refer to Section 8W.


  • When Monitored:

    Ignition on and battery voltage above 10.4 volts.

  • Set Condition:

    The fuel level sensor signal voltage goes below 0.4 of a volt for more than 90 seconds. One Trip Fault. Three good trips to turn off the MIL.


Possible Causes
 
(N4) FUEL LEVEL SIGNAL CIRCUIT SHORTED TO GROUND
 
(N4) FUEL LEVEL SIGNAL CIRCUIT SHORTED TO THE (K900) SENSOR GROUND CIRCUIT
 
FUEL LEVEL SENSOR
 
TIPM
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)



Diagnostic Test

1.FUEL LEVEL SENSOR VOLTAGE BELOW 0.4 OF A VOLT

NOTE: Diagnose any CAN - B or CAN -C Communication DTCs before continuing.





Is the Fuel Level Sensor voltage below 0.4 of a volt?

Yes
  • Go To 2


No

2.FUEL LEVEL SENSOR








Did the Fuel gauge level change from empty to full?

Yes


No
  • Go To 3

3.(N4) FUEL LEVEL SIGNAL CIRCUIT SHORTED TO GROUND







Is the resistance below 100 ohms?

Yes


No
  • Go To 4

4.(N4) FUEL LEVEL SIGNAL CIRCUIT SHORTED TO THE (K900) SENSOR GROUND CIRCUIT





Is the resistance below 5.0 ohms?

Yes


No
  • Go To 5

5.TOTALLY INTEGRATED POWER MODULE

NOTE: Before continuing, check the TIPM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.





Were any problems found?

Yes


No