B190F–DRIVER WINDOW SWITCH CIRCUIT HIGH–DDM

For a complete wiring diagram Refer to Section 8W.

Theory of Operation

This test shows graphics, circuit numbers and text for a Left Hand Drive (LHD) vehicle. For a Right Hand Drive (RHD) vehicle, refer to the schematic for the different circuit numbers, cavities and names.

When Monitored:
Continuously
Set Condition:
When the Driver Express Switch Driver Window Mux circuit is over 5.6 volts for over 100 ms.

Possible Causes

(Q221) (LHD) MASTER SWITCH LEFT FRONT WINDOW MUX CIRCUIT SHORT TO VOLTAGE

(Q222) (RHD) MASTER SWITCH RIGHT FRONT WINDOW MUX CIRCUIT SHORT TO VOLTAGE

DRIVER WINDOW/DOOR LOCK SWITCH

DRIVER DOOR MODULE

Diagnostic Test

1.TEST FOR INTERMITTENT CONDITION

Does the scan tool display B190F–DRIVER WINDOW SWITCH CIRCUIT HIGH?

Yes

Go To 2

The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

2.DRIVER WINDOW/DOOR LOCK SWITCH SHORTED

Does the scan tool display B190F–DRIVER WINDOW SWITCH CIRCUIT HIGH?

No

Replace the Driver Window/Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

Yes

Go to 3

3.(Q221) DRIVER EXPRESS SWITCH DRIVER WINDOW MUX CIRCUIT SHORT TO VOLTAGE

Is there any voltage present?

Yes

Repair the (Q221) Driver Express Switch Driver Window Mux circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

Replace the Driver Door Module in accordance with service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)