B183A–PASSENGER DOORS UNLOCK CONTROL CIRCUIT HIGH– CLUSTER

For a complete wiring diagram Refer to Section 8W.

When Monitored:
Continuously
Set Condition:
When the Cluster senses a high condition on the (P292) Door Unlock Relay Control circuit for over 10 seconds, this code will set.

Possible Causes

(P292) DOOR UNLOCK RELAY CONTROL CIRCUIT SHORT TO BATTERY

JUNCTION BLOCK

INSTRUMENT CLUSTER

1.TEST FOR INTERMITTENT CONDITION

Does the scan tool display B183A-PASSENGER DOORS UNLOCK CONTROL CIRCUIT HIGH?

Yes

The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

2.DOOR UNLOCK RELAY SHORTED TO BATTERY

NOTE: Ensure the windows are down before proceeding.

Did the doors unlock?

Yes

Replace the Instrument Cluster in accordance with service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

3.(P292) DOOR UNLOCK RELAY CONTROL CIRCUIT SHORTED TO BATTERY

Is there any voltage present?

Yes

Repair the (P292) Door Unlock Relay Control circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

Replace the Junction Block in accordance with service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)