POWER BRAKE BOOSTER - RIGHT-HAND-DRIVE
NOTE: Before power brake booster (1) installation, be certain a NEW dash seal (2) is installed on the booster mounting studs.
CAUTION: Because of power brake booster design, it is very important to tighten the mounting nuts in the proper sequence.
(Refer to 6 - CLUTCH/MASTER CYLINDER - INSTALLATION)
Do not reuse the old clip.
CAUTION: Do not reuse the original stop lamp switch. The switch can only be adjusted once. That is during initial installation of the switch. If the switch is not adjusted properly or has been removed for some service, a new switch must be installed and adjusted.
(Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/STOP LAMP SWITCH - INSTALLATION)
(Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION)
(Refer to 5 - BRAKES/HYDRAULIC/MECHANICAL/MASTER CYLINDER - INSTALLATION)
CAUTION: When installing the vacuum hose on the check valve (1), make sure the hose is routed properly to avoid possible contact with unfriendly surfaces.
(Refer to 8 - ELECTRICAL/WIPERS/WASHERS/WASHER RESERVOIR - INSTALLATION)
(Refer to 19 - STEERING/PUMP/RESERVOIR - INSTALLATION)
(Refer to 7 - COOLING/ENGINE/COOLANT RECOVERY CONTAINER - INSTALLATION)
(Refer to 14 - FUEL SYSTEM/FUEL INJECTION/O2 SENSOR - INSTALLATION)
(Refer to 9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION)
(Refer to 5 - BRAKES - STANDARD PROCEDURE)
(Refer to 24 - HEATING & AIR CONDITIONING - STANDARD PROCEDURE)
WARNING: Be certain a firm brake pedal is achieved prior to attempting to operate the vehicle.