P0602-CONTROL MODULE PROGRAMMING ERROR/NOT PROGRAMMED

For a complete wiring diagram Refer to Section 8W.

Theory of Operation


The controller is programmed during manufacturing with generic software to facilitate testing. This software does not have the proper calibrations to control a transmission in a vehicle. The check for generic software is made at power-up. If generic software is found, the MIL will light immediately and the MIL will stay on even if the fault is cleared, until the proper software is installed. Note: Transmission will be placed in limp-in mode.


  • When Monitored:

    Check for generic software is made at power-up.

  • Set Condition:

    If generic software is found, the MIL will light immediately. This DTC is designed to signal the technician that the controller still has generic software installed.


Possible Causes
 
PCM - PROGRAMMING ERROR
 


Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)



Diagnostic Test

1.CONTROL MODULE PROGRAMMING ERROR

NOTE: Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.





Verify that the controller updated successfully.

Test Complete